first shoulder tester print

i got my turn on the 3d printer, and there is something really striking about the cyan and yellow combination (specifically sunflower yellow).

well, the columns didn't print the greatest; there was a lot of fuzzy beard up to the z level of the walls. i tried to sand them down but at some point i ended up breaking one off. i was able to wedge it back in from the bottom so that i could test the shoulders.

i may just print the columns separately and wedge them into the case; it will give a optional color offset. alternatively i may make these screws; it's possible these will be subjected to too much force.

these actually feel pretty good for shoulder buttons, too! so that's a success. but i'll definitely be curious how they feel with a button to activate.